Depliant: 

SFL_-_forbici_pedanine_low_profile_U.pdf

Russian catalogue  

SFL 5516  - SFL 5518  - SFL 5518 T - SFL 5535  - SFL 5540

The evolution of RAV scissors lifts.

Ideal for space saving.

The best alternative to recessed installation.

DESIGN FEATURES

No cross rails or torsion bars between lifting platforms (for maximum accessibility in the working area).

Hydraulic levelling system, by means of a patented synchronisation device, assures constantly the level of the lifting platforms regardless of weight distribution.

All mechanical, hydraulic and electrical components are manufactured in compliance with the respective European Safety Standard.

Low voltage controls (24 V).

Controlled speed during initial lifting and final lowering phase.

Audible alarm during the final lowering phase.

All pivot points made with self lubricating bushings for long life.

SFL 5516/ 2500 kg
SFL 5518 / 3000 kg

The minimum height from the floor guarantees easy and rapid positioning of the vehicle on the lift.

The limited space required by the lift improves safety of the working area.

Ideal for mechanical repairs, type shops and rapid fit facilities. It is also a good choice for service reception areas.

SFL 5518T / 3000 kg (H min. = 95 mm)

SFL 5535 / 3500 kg (H min. = 100 mm)

Extra low version. The lift is an ideal choice for low ground clearance vehicles of all types and in particular for extra low spoilers.

The lift is strongly recommended for vehicles with variable height, or damaged suspensions.

SFL 540 / 4000 kg (H min. = 135 mm)

High capacity model with longer lifting plates.

RECESSED VERSIONS

SFL 5516 I - SFL 5518 I - SFL 5518 TI - SFL 5535 I - SFL 5540 I

The very low profile of the lift allows recessed installation even in special conditions where it would not be possible to build pits deep enough for this type of lift.

Technical data and composition presented in this web site may vary.
Pictures reproduced are only indicative.